View Single Post
  #6   Spotlight this post!  
Unread 20-01-2005, 02:06
KVermilion's Avatar
KVermilion KVermilion is offline
... clearly ...
#0649
 
Join Date: Jan 2005
Location: Saratoga, Ca
Posts: 52
KVermilion is infamous around these parts
Re: The Hall Effect sensor wiring?

Quote:
Originally Posted by jgannon
That is only necessary if the voltage supply is very noisy. I'm pretty sure that the outputs on the RC are fairly stable and well-regulated, so you can connect the sensor directly to the RC.
"The on-chip voltage regulator provides immunity to power supply variations between 4.5V and 26.5V. However, even while operating from a regulated line, some supply and output filtering is required to provide immunity to coupled and injected noise on the supply line." -- ATS660LSB Data Sheet, Pg 10