Thread: pic: 488 Arm Prototype
View Single Post
  #7   Spotlight this post!  
Unread 24-01-2005, 22:50
Mr. Ivey's Avatar
Mr. Ivey Mr. Ivey is offline
Mark Ivey
AKA: Mark
no team
  
Join Date: Sep 2002
Rookie Year: 2000
Location: Raleigh, NC
Posts: 171
Mr. Ivey is a glorious beacon of lightMr. Ivey is a glorious beacon of lightMr. Ivey is a glorious beacon of lightMr. Ivey is a glorious beacon of lightMr. Ivey is a glorious beacon of light
Send a message via AIM to Mr. Ivey
Re: pic: 488 Arm Prototype
Just to re-state the obvious... that is a whole lot of air being used... just a suggestion, to take the other side of what Stephen Kowski said about lowering the pressure. You could lower the volume of what you have to fill. P1V1=P2V2 so you can change volume or pressure. Just a suggestion if you are worried about air problems, lower the pressure to say 40psi or so, and downsize the diameter of the piston. Sacrifice a little of both, just my two cents.
ivey
__________________
When you tell a student not to do it, you shouldn't do it. Or else you will wind up with a 3/8" drill bit in your finger... Like I did...
Reply With Quote