[Obi]

In my custom code, I have three positions I set the pan and tilts to. None of them are the 127,127 position, but wheneverI change them, they immediately move back to 127,127. Is there code in other parts that set the servos to 127,127 after initializing or anything? Thanks.

Edit:
Also, is there a way to use the camera_set_servo command and not have to do camera_init again? Everytime, after I initialize the camera and tell it to go to a specific servo position, I don't get any camera feedback. And if I try to initialize again, it goes back to 127,127. Thanks.