[roboguy #1]

Well so far the worst injury physically was when a mentor of the was threading a well ground shaft through a bearing and got slaughtered by the key way. Lets just say the bearing his hand and the shaft were nice and red. His hand in 2 places. Next I'm trying to hammer a bearing out of a hole( yes I used a perfectly calculated screw that was just utterly perfect) that is until I kinda missed the screw and well Mr. Team captain decided to protect the Scrap piece from last years robot with his finger. But the broken bits end mills and drill bits total about 3 all together. Aren't good but Its Mr. Co-Captain that is good at sooting them at people. And that $@#$@#$@#$@# new drill bit its sharp when you decide to twist it in your fingers to unjam it because you stuck it in a pre-drilled hole. Also Gotta remember I come to robotics today and look at the tower we have it has a endmilled team number on it and on another side it doesnt resemble it. I finally remember ( I said hey Yoni How did the drill bit work on milling that aluminum) well you get the idea when someone trys to mill numbers into aluminum with a drill bit.