|
Re: Team 804 Electronics (completeness)
You can polish the edge of the board by "flaming" it with a propane torch. Be careful to do it lightly because you do not want to deform or burn the plastic. Try a test piece first. I have no idea if this will make the LEDs look good or not, but that is how to get rid of the rough cuts.
__________________
Teacher/Engineer/Machinist - Team 696 Circuit Breakers, 2011 - Present
Mentor/Engineer/Machinist, Team 968 RAWC, 2007-2010
Technical Mentor, Team 696 Circuit Breakers, 2005-2007
Student Mechanical Leader and Driver, Team 696 Circuit Breakers, 2002-2004
|