Thread: Van Door motor help
View Single Post
  #3   Spotlight this post!  
Unread 10-02-2005, 09:19
Ben Piecuch Ben Piecuch is offline
Bengineer
no team
Team Role: Engineer
  
Join Date: Jun 2001
Rookie Year: 2000
Location: Providence, RI
Posts: 336
Ben Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond reputeBen Piecuch has a reputation beyond repute
Re: Van Door motor help
Just another note on the Van Door Motor... The shaft itself is 11mm, which is close enough to 7/16" to work. We tried to find an 11mm drill bit locally, but could only find them through McMaster or similar sites. To mount a sprocket on the shaft, we used a 5/8" bore sprocket and made a spacer to fit between it and the shaft. We then drilled through all three and pinned them together. (5/32 dowel pin)

Bengineer
GUS, Team 228