Quote:
|
Originally Posted by Steve W
Did you wire the battery across the terminals? The terminals are suppose to have a wire that goes to you contoller board that gives an open or closed message to the controller. AT NO TIME should you wire any current across this sensor. The compressor is turned on and off by a spike that is controlled by the main contoller after reading the pressure sensor. I hope that this is of value.
|
Oh no, I meant during testing. We have it all hooked up into the main controller and through spikes, the whole deal, we check it a thousand times, we ruled out all the possiblities. It's definetly the pressure switch.
Thanks for your help though!