Thread: Are 100k Ohm pots necessary?
View Single Post
  #22   Spotlight this post!  
Unread 18-02-2005, 08:37
Kyle Fenton Kyle Fenton is offline
GET IT ON!!
FRC #0121 (Rhode Warrior)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 2000
Location: Middletown, R.I.
Posts: 785
Kyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud ofKyle Fenton has much to be proud of
Send a message via AIM to Kyle Fenton
Re: Are 100k Ohm pots necessary?
Rhode Warrior 8 uses 10k pots, and we haven't had any problems with them. The numbers on the programming output always vary a little, but we built in a tolerance factor to correct for that.
__________________
121
Rhode Warriors
NAVSEA/Raytheon/URI/Middletown, Portsmouth, Tiverton, Mt. Hope HS
Quality Robots Since 1996