|
Dumb question about wiring custom controls
Everything that I run from the control ports has to be attached to the ground pin right? Whether it be a potentiometer or a switch it needs to have 5v to the 5v pin the signal pin connected to a signal pin and the ground pin connected to the ground. Do I just end up attaching all those grounds and solder them to the one ground pin/s?
__________________
If either a public officer or any one else saw a person attempting to cross a bridge which had been ascertained to be unsafe, and there were no time to warn him of his danger, they might seize him and turn him back without any real infringement of his liberty; for liberty consists in doing what one desires, and he does not desire to fall into the river. -Mill
|