View Single Post
  #24   Spotlight this post!  
Unread 07-03-2005, 17:05
cdawzrd's Avatar
cdawzrd cdawzrd is offline
Vice-President of Caffine
AKA: Jonathan
#0619 (CA Robotics)
Team Role: Programmer
 
Join Date: Feb 2004
Rookie Year: 2001
Location: Charlottesville, Virginia
Posts: 63
cdawzrd will become famous soon enough
Send a message via AIM to cdawzrd
Re: Drive Assembly Sprockets are Custom Bored

Quote:
Originally Posted by Joel Glidden
You could also turn down the output shafts to 5/8" on your handy dandy lathe. You could also mill a 3/16" keyway on the opposite side of the shaft from the existing 5mm keyway.

-Joel
Keep in mind now, the most advanced piece of machinery we have is a drill press... no lathe, no mill, so if we had been in the same problem (which we weren't, but anyway), we would have had to get the sprockets custom-made by some machine shop.
__________________
Cdawzrd
>> www.cdawzrd.com <<
>> www.carobotics.org <<