Quote:
|
Originally Posted by KenWittlief
If you had used a Craftsman wrench, you could take it back to Sears when you were done, and they would replace it, no questions asked.
BTW, what does it take to drill a 1/4" hole through a wrench handle? Arnt those things made of hardend chrome steel?
|
We actually thought about that, but we wanted to keep our Craftsman stuff, and we aren't planning on removing it any time soon.
It took about ten minutes on the drill press, with two people. The first to hold the wrench and the other to put on some oil every three seconds or so. It was very tedious. (As a rookie I was assigned to the oil).