|
Re: Gyro problems - again - Team 1286
This may seem like a weird question, but oh well... How do you wire the BEI AQRS-0075-FIRST gyrochip?
I read the readme but it only gives instructions for wiring other gyros. I suppose you need to wire the white cable to rate out pin1, the ground black wire to common pin2, and the red wire to +5 VDC input pin3. I think that is how it goes, but i just want to make sure is right before i blow something out. Any quick reply will be greatly appreciated.
Thanks.
__________________
Join the Red revolution, give me some RED rep!!!!
if it doesn't work, don't force it. Go get a bigger hammer.
int run = 0;
int robot_chasing_you = 1;
if (robot_chasing_you)
{
run = 254; 
}
I got 48 Gmail invites left, pm me with your e-mail so i can send you one.
|