|
Re: CIM-MOTOR source
Quote:
|
Originally Posted by Andrew Schuetze
Can somebody refresh my memory as the current bot is waiting for us in Houston? Does this year's CIM motor have the same output shaft as either or both of the last two year's? If so then I can get by with gutting old machines. I've sent a request into the CIM folks via their website. I'll post here if I get any response.  |
I remember this years KEYWAY was slightly different in that it wasn't cut the entire length of the shaft, I think it stopped about 1/2" short of the end of the shaft. You could tell it was cut with an end mill, where as 2003 and 2004 CIMs keyway was cut with a keyway cutter. However, they both use the same size metric 2mm keystock. Other than that the rest of the shaft seems unchanged.
__________________
Work Hard, Have Fun, Make a Difference!
Last edited by Doug G : 26-03-2005 at 22:42.
|