I'm trying to do an analysis of a frame in Pro/Engineer, and I need to enter material properties. No one in the office has an engineering handbook with the values I need, and even Google is having problems finding what I am after. I'm looking for the material properties of type 304 Stainless Steal (304SS). If anyone could point me in the right direction, that'd be great! Below is what Pro/E spit out at me...
Code:
MATERIAL 304SS
This file may be edited using available editor.
Just type on the necessary lines appropriate values
after the "=" sign. Comments are not permitted on
lines containing material properties names.
YOUNG_MODULUS =
POISSON_RATIO =
SHEAR_MODULUS =
MASS_DENSITY =
THERMAL_EXPANSION_COEFFICIENT =
THERM_EXPANSION_REF_TEMPERATURE =
STRUCTURAL_DAMPING_COEFFICIENT =
STRESS_LIMIT_FOR_TENSION =
STRESS_LIMIT_FOR_COMPRESSION =
STRESS_LIMIT_FOR_SHEAR =
THERMAL_CONDUCTIVITY =
EMISSIVITY =
SPECIFIC_HEAT =
HARDNESS =
CONDITION =
INITIAL_BEND_Y_FACTOR = 5.000000E-01
BEND_TABLE =
PRO_UNIT_MASS =
PRO_UNIT_LENGTH =
PRO_UNIT_SYS = millimeter Kilogram Sec (mmKs)