View Single Post
  #4   Spotlight this post!  
Unread 07-04-2005, 13:47
Kevin Sevcik's Avatar
Kevin Sevcik Kevin Sevcik is online now
(Insert witty comment here)
FRC #0057 (The Leopards)
Team Role: Mentor
 
Join Date: Jun 2001
Rookie Year: 1998
Location: Houston, Texas
Posts: 3,600
Kevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond repute
Send a message via AIM to Kevin Sevcik Send a message via Yahoo to Kevin Sevcik
Re: Online Engineering Tables

EFunda: AISI Type 304

That should be most all you need. Shear modulus could be calculated, but you can probably leave it blank. The tension and compression stresses are defined by you, really. Typically you design to yield as a first iteration. Shear limit can be calculated as well. Emissivity doesn't matter unless you're doing thermal modelling, and even then is highly dependent on surface finish. Condition probably doesn't matter, nor should anything below it.
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter
Reply With Quote