Quote:
|
Originally Posted by crazykid234
To sweep the bike like you are talking about, draw a circle (make sure you are in the correct plane)somewhere on the line, and click sweep, the sweep feature should create an extrusion of the circle wherever the bike outline goes. You may need to draw your circle on the end point of the bike outline.
|
yea I did this, but it only does part of it, since the bike is not just one simple line but rather 5 lines connected and splitting at various points.
It works somewhat, if i do it for every "line" seperatly, but then it doesn't connect...
Thanks for the help!