Quote:
|
Originally Posted by sanddrag
Try to start by drawing only the outer perimeter in the sketch. You should be able to sweep that once through. Then make a new sketches for the other lines, and sweep those one at a time.
|
Thanks, i didn't think about it and I'll give it a try the next time I come near Autodesk (monday).
Quote:
|
Originally Posted by JasJ002
You could also use something else as your bas and then build the tubing via 3D sketch. If you wanna know more about that just ask I don't know if it would work well or not. but thats what I used for the tubes and the wires on our robot. once you get the process down it's pretty easy.
|
Ok, I'll give this a try too.