Thread: 16F84 HELP!!!
View Single Post
  #24   Spotlight this post!  
Unread 08-09-2005, 19:24
Unsung FIRST Hero
Mike Betts Mike Betts is offline
Electrical Engineer
no team
Team Role: Engineer
 
Join Date: Dec 2001
Rookie Year: 1995
Location: Homosassa, FL
Posts: 1,442
Mike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond reputeMike Betts has a reputation beyond repute
Re: 16F84 HELP!!!

Quote:
Originally Posted by sparksandtabs
IC-Prog does not work fine, everytime i hit the compile button the program just freezes up

Also, where can I purchase something for it that would run at 4 mhz, I believe that I would need a Resonator, is this correct
As you stated, let's start over. From now on, I am making all references to the University of Texas web site...

You do not need an oscillator to program the chip. Only the components noted here.

You do not need to compile anything right away. Just use the TEST1.HEX file provided here.

You do need a crystal oscillator to test the chip with the TEST1.HEX program loaded as shown here.

You will also note a rather extensive debugging list here in the event that you have problems with IC-PROG. Of particular note are the special drivers required for XP operation.

Are you sure that you have followed the instructions indicated?

Mike
__________________
Mike Betts

Alumnus, Team 3518, Panthrobots, 2011
Alumnus, Team 177, Bobcat Robotics, 1995 - 2010
LRI, Connecticut Regional, 2007-2010
LRI, WPI Regional, 2009 - 2010
RI, South Florida Regional, 2012 - 2013

As easy as 355/113...