Quote:
|
Originally Posted by troy_573
Its this little blue thing with a small shaft sticking out of it, looks just like a rotary encoder ... i can make the question so you dont have to under stand how a pot. works .... we preety much need to attach a 1/4"(?) shaft to a 3/8" shaft
|
ahh... um how much torque is gonna be on these? at worst ducttape them together.. or get a bushing on the 1/4 shaft with a OD of 3/8 and then get another bushing of inner diameter of 3/8 and go over both the 3/8 shaft and the 3/8 bushing which is over the 1/4 shaft and then drill a hole through both ends and tap a pin through them