Thread: Extending a cantilevered drive shaft.
View Single Post
  #15   Spotlight this post!  
Unread 03-11-2005, 22:03
Andy Baker's Avatar Woodie Flowers Award
Andy Baker Andy Baker is offline
President, AndyMark, Inc.
FRC #3940 (CyberTooth)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1998
Location: Kokomo, Indiana
Posts: 3,412
Andy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond repute
Send a message via AIM to Andy Baker
Re: Extending a cantilevered drive shaft.
Quote:
Originally Posted by sanddrag
And I too am curious as to what that little peg is in the hex portion of the shaft in that AM photo.
That is simply a 3/32" roll pin. It serves the purpose of holding a gear in place on the shaft. It is much cheaper than machining a step.

Andy B.