|
Re: Strange Behavior
could be:
1. an error in your SW. Were code changes made before this erratic behaviour started? can you download your last known-good code again? If the SW jumps out of its loop, then your bot will go berzerk
2. a loose wire to the power on your RC.
3. power problem with your controller? loose wires on your controller? Joysticks or custom controllers plugged into the wrong ports?
NOTE: If the bot wacks out with the tether attached then it cannot be: someone transmitting on the same frequency, or a problem with your receiver.
If you cant isolate the cause, you might have a defective robot controller, or operator interface.
|