Thread: Bend Radii
View Single Post
  #4   Spotlight this post!  
Unread 08-11-2005, 00:30
Unsung FIRST Hero
JVN JVN is offline
@JohnVNeun
AKA: John Vielkind-Neun
FRC #0148 (Robowranglers)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 2000
Location: Greenville, Tx
Posts: 3,159
JVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond reputeJVN has a reputation beyond repute
Re: Bend Radii
Quote:
Originally Posted by Jeff Pahl
1/16" = 0.062(5). It's probably a typo where someone dropped the 0
This is correct.
The bend radii is determined by the die used in the sheet-metal break.
Our typical sizes are .032", .046", .062", etc...

Andrew,
Where is this misnotated?
How sloppy of me.

JV
__________________
In the interest of full disclosure: I work for VEX Robotics a subsidiary of Innovation First International (IFI) Crown Supplier & Proud Supporter of FIRST