Thread: Power output on I/O port
View Single Post
  #1   Spotlight this post!  
Unread 01-12-2005, 02:53
Leet_T3chn0 Leet_T3chn0 is offline
Registered User
no team
  
Join Date: Dec 2005
Location: CA
Posts: 6
Leet_T3chn0 is an unknown quantity at this point
Power output on I/O port
I'm trying to mess around with the controller, and what I'm trying to reach is to provide >7 volt out of either an I/O or motor port on Channel 6.

I've noticed that the three ports are:
- Common gound
- V++
- Control

The control signal is minimal power, and the V++ plug is constent.

I was thinking of some sort of tri-state buffer, or relay so that the control signal will open up the V++...

Anyone have any ideas for me?