Thread: Connector for gyro chip
View Single Post
  #9   Spotlight this post!  
Unread 16-12-2005, 21:36
Tom Bottiglieri Tom Bottiglieri is offline
Registered User
FRC #0254 (The Cheesy Poofs)
Team Role: Engineer
  
Join Date: Jan 2004
Rookie Year: 2003
Location: San Francisco, CA
Posts: 3,186
Tom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond reputeTom Bottiglieri has a reputation beyond repute
Re: Connector for gyro chip
You should be able to use 2 PWM cables to connect to the pins. Just check the spec sheet to see where each wire should go.