Thread: Carbide Drilling Tolerances
View Single Post
  #5   Spotlight this post!  
Unread 22-12-2005, 04:20
sanddrag sanddrag is offline
On to my 16th year in FRC
FRC #0696 (Circuit Breakers)
Team Role: Teacher
  
Join Date: Jul 2002
Rookie Year: 2002
Location: Glendale, CA
Posts: 8,510
sanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond repute
Re: Carbide Drilling Tolerances
A reamer is definitely a good way to go. Just make sure you use a good lathe that is all in spec and a good chuck that is in spec as well. Mcmaster should have reamers in .0005 increments
__________________
Teacher/Engineer/Machinist - Team 696 Circuit Breakers, 2011 - Present
Mentor/Engineer/Machinist, Team 968 RAWC, 2007-2010
Technical Mentor, Team 696 Circuit Breakers, 2005-2007
Student Mechanical Leader and Driver, Team 696 Circuit Breakers, 2002-2004