|
Re: Carbide Drilling Tolerances
So, the question is, should I buy the .3120 reamer, and be right on tolerance(assuming no tool slop) or go with the .3115 reamer, which is still within tolerance, but would give me a bit of play as far as oversize goes. Does a typical reamer end up making a bigger hole, or a smaller hole due to tool wear?
__________________
Reading makes a full man, conference a ready man, and writing an exact man. -Sir Francis Bacon
"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction."
-Albert Einstein
|