|
Re: Carbide Drilling Tolerances
Thanks. Now, the cost difference between a carbide and a HSS reamer is pretty big -$15 vs. $45- so would a HSS reamer that was only correcting a few thousands be able to tackle a hardened steel? This will only be used a few times a year, so if we can keep it on the cheap, good, if we can't, theres no point in buying junk.
__________________
Reading makes a full man, conference a ready man, and writing an exact man. -Sir Francis Bacon
"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction."
-Albert Einstein
|