Quote:
|
Originally Posted by CarpeDiem
from the manual i have tried to hook up the camera to the rc and nothing happens can anyone tell me what i am doing wrong, and where does the pwm cable hook into the cmucam from the ttl board on the rc?
|
What do you have hooked up? Do you have the two servos hooked up to the correct pwms, and is the jumper connected for external power to the servos?
Do you have a pwm cable connected between an unused pwm output and the power connecter on the camera (the 3 pin female connecter located below the camera lens)?
The ttl-rs232 connector goes from the three pin female connecter near the serial port on the camera board to the 4 pin ttl connecter on the RC (located near the program button.
Hope this helps,