|
Re: CIM motor shaft Coupler
It's a 5/16" output shaft. You can buy combination couplers, or you could just machine a 5/16" hole on one side of a piece of stock, and a 5/8" hole on the other. Or 5/8 ouput shaft.
EDIT----------------------------------------------------------------
Its an 8mm shaft. I was close... 
__________________
Reading makes a full man, conference a ready man, and writing an exact man. -Sir Francis Bacon
"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction."
-Albert Einstein
Last edited by Andrew Blair : 13-01-2006 at 20:52.
|