Quote:
|
Originally Posted by JamesBrown
Did this happen before or after you downloaded the code. If it was before the code was downloaded reinstall the master code on the controller an try again. If it is after the code is downloaded then check the code and make sure no one changed any thing.
|
It happens before downloading the code. We learned tonight that if we disable the robot via the competition port, it does the same thing after a short delay.
Where can I get the 2006 Master Code? The latest I could find was the one from April 2005 and I didn't want to load something that old into a new controller set.
After our code is loaded, the robot behaves itself completely. It is only when it is disabled or in programming mode that it get wierd.
Lynn (D) - Team Voltage 386