Thread: Tether Pinout
View Single Post
  #1   Spotlight this post!  
Unread 15-01-2006, 18:33
roboticsguy1988's Avatar
roboticsguy1988 roboticsguy1988 is offline
Larry Johnston
AKA: Larry Boy
FRC #1501 (Team THRUST)
Team Role: Electrical
  
Join Date: Jan 2004
Rookie Year: 2001
Location: Huntington, IN
Posts: 290
roboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud ofroboticsguy1988 has much to be proud of
Send a message via ICQ to roboticsguy1988 Send a message via AIM to roboticsguy1988 Send a message via MSN to roboticsguy1988 Send a message via Yahoo to roboticsguy1988
Question Tether Pinout
Ok before i ask i would like to state that i ahve searched the forum and the only post i found that was close was clear back in 2002 so i am afarid it might be out of date.

Does anyone know the exact pinout for the tether port on the Robot Controller? Does it use all 9 pins, or jsut a few?
__________________
Larry Johnston, Team THRUST, Team #1501, Team THRUST webpage

2005 IRI - Imagery and Design Award
2005 - 2006 BMR - Professional Grade Award
2006 BMR - Delphi Driving Tomorrow's Technology Award
"That can't be their 'bot. not nearly enough (if any) rivets to be a 1501 machine." ~ RogerR
~Da team that uses all tha rivets, Team #1501~

The FIRST Software Repository ~ Chief Admin
openFIRST ~ Project Supporter (Former editor)
DMOZ.org - FIRST - US Teams Section ~ Chief Editor