Thread: CMUcam default code not responding
View Single Post
  #5   Spotlight this post!  
Unread 17-01-2006, 09:11
Kyveck Kyveck is offline
Registered User
FRC #1014 (Dublin Robotics)
Team Role: Programmer
  
Join Date: Jan 2006
Location: Ohio
Posts: 16
Kyveck is an unknown quantity at this point
Re: CMUcam default code not responding
I ran the serial port diagnostic tests. In loopback mode, terminal input was not echoed. When connected to the camera, there was no responce. I am confident that I configured everything per the ReadMe file.

When I ran debug, the following was printed to the terminal:
Camera: Initialized abnormally with code 131
Camera: Initialization state = 1
Camera: Initialization state = 2
Camera: Initialization state = 3

I hope to test the TTL to RS232 board soon using the ifi instructions.
Thank you for your help.
Kyle W