Quote:
|
Originally Posted by PhilBot
Hi Kevin...
Excellent code. I'm trying to get some early Auto-Heading code testing done using an existing Robot. I was hoping I could use the team's little 2003 EDU robot as a test platform.
I'm an experienced embedded programmer, but new to the IFI hardware.
I tried deploying your gyro code on the small EDU controller. I discovered that when I included the new ADC module I got a program run error light, so I dropped back to the standard iti_utilities code for the ADC conversion. (I assumed a basic hardware incompatibility....)
My only problem is that now I'm not sure where to put the call to Process_Gyro_Data().
I'd like to put it in User_Routines_Fast.c but I don't have your ADC code installed so I don't know when the converters have got new values. D'oh.
Am I flogging a dead horse here, or is there a simple way to use the standard IFI analog utilities to drive your Gyro code? I'm only using a single analog channel (for the Gyro) so that may simplify things. I don't need fully calibrated data for my initial testing... I just need it to basically run. If I can get the calls IN, I can get the rest to work.
Thanks for your time.
Phil.
|
Phil,
Gyro code for the EDU-RC can be found on my website.
-Kevin