We seem to be having the exact same problem (the error is the same) ...except we haven't been as fortunate. In 10 hours' time we've migrated from computer to computer, tested thousands of different cables to check signal transmission, and for some reason we just can't seem to capture any images at all in Labview (or, just to make matters worse, it worked perfectly fine earlier this same day for a few moments and out of nowhere it decides to go beszerk on us)
- we have connected the camera to the controller via the PWM cable
- we've connected the camera to the pc with the serial connection through com1, changed the baud rate to 115200 (etc)
- i trust labview & its driver have been installed properly
- both leds on the sensor light up when the camera is turned on
any ideas or suggestions - as wild as they may seem! - will greatly be appreciated at this moment
i'm just about ready to pull my hair out
thanks...
__________________
1382 Tribotec Team - Brazil
-----------------------------------------------
2005 NJ Regional GM Industrial Design Award
2005 NJ Regional Website Excellence Award
2004 NJ Regional Semifinalists
-----------------------------------------------