Quote:
|
Originally Posted by lupjohn
Check online to find your local Gates Rubber Power transmission products dealer. The belt is 15mm wide with a 3mm pitch and comes in a number of circumferences ( read belt length) measured in mm. I needed a belt approximately 300mm in length. They also sell the matching sprockets for the driven end of your belted drive train again with 15mm width and 3mm pitch. The motor sprocket is 16 tooth so any multiple of 16 gives the desired gear reduction ratio. I.E. 16:48 is 1:4 reduction ratio. I ordered my locally through Motion Industries and will take 5-7working days for delivery. Hope this helps out. Best wishes, LRU.
|
I believe you're referring to the CIM motor. The FP motor comes with a gear, not pulley on it's output shaft.
Furthermore, I don't even see a motor with the model number that the original post references.