Thread: Shaft size of Big "FP" CIM Motor
View Single Post
  #4   Spotlight this post!  
Unread 18-01-2006, 18:32
Joe Johnson's Avatar Unsung FIRST Hero
Joe Johnson Joe Johnson is offline
Engineer at Medrobotics
AKA: Dr. Joe
FRC #0088 (TJ2)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1996
Location: Raynham, MA
Posts: 2,631
Joe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond repute
Re: Shaft size of Big "FP" CIM Motor
Quote:
Originally Posted by Al Skierkiewicz
I have it on reliable source that it is 5/16" with a flat ground on one side.
Hmmm I thought it was 8mm (.315"). It is only 2-3 thousandths of an inch differenence (5/16=.3125")

Anybody have a tie breaker?

I just check the step file on AndyMark.biz: Andy has modelled the shaft as 8mm with a flat at distance of 3.531mm (.139") from the centerline (= 7.531mm= .269" from the OD opposite the flat to the flat).

I hope this helps.

Joe J.
__________________
Joseph M. Johnson, Ph.D., P.E.
Mentor
Team #88, TJ2