Thread: New Gear Tooth Sensor- Connection
View Single Post
  #7   Spotlight this post!  
Unread 20-01-2006, 23:53
Jared Russell's Avatar
Jared Russell Jared Russell is offline
Taking a year (mostly) off
FRC #0254 (The Cheesy Poofs), FRC #0341 (Miss Daisy)
Team Role: Engineer
  
Join Date: Nov 2002
Rookie Year: 2001
Location: San Francisco, CA
Posts: 3,078
Jared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond reputeJared Russell has a reputation beyond repute
Re: New Gear Tooth Sensor- Connection
You can use solder if you have a very steady hand and a small iron, but I don't know if that might cause problems with the sensor itself. A little bit of hot glue or epoxy should do the trick