Thread: How to remove pulley from CIM motor
View Single Post
  #8   Spotlight this post!  
Unread 21-01-2006, 23:11
lukevanoort lukevanoort is offline
in between teams
AKA: Luke Van Oort
no team
  
Join Date: Oct 2005
Rookie Year: 2005
Location: Waterloo, ON, Canada
Posts: 1,873
lukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond reputelukevanoort has a reputation beyond repute
Send a message via AIM to lukevanoort
Re: How to remove pulley from CIM motor
Quote:
Originally Posted by RY-GUY
You can also get the gear up by heating it up with a bunsen burner and then pry it off with two screw drivers. Just FYI.
This method works GREAT! In fact, it is so good, that our biggest problem was removing the snap ring from the shaft, not the pulley. (Although that beefy spring caused more anxiety)
__________________
Team 1219: 2009 - Mentor
Team 587: 2005 - Animator, 2006-2008 - Team Captain