Thread: Gyro Code Problems
View Single Post
  #8   Spotlight this post!  
Unread 27-01-2006, 10:45
ldeffenb ldeffenb is offline
Registered User
AKA: Lynn Deffenbaugh (Mr)
None #0386 (Team Voltage 386)
Team Role: Mentor
  
Join Date: Jan 2005
Rookie Year: 2003
Location: Florida
Posts: 75
ldeffenb has a spectacular aura aboutldeffenb has a spectacular aura aboutldeffenb has a spectacular aura about
Send a message via ICQ to ldeffenb Send a message via AIM to ldeffenb Send a message via Yahoo to ldeffenb
Re: Gyro Code Problems
Quote:
Originally Posted by naor52
i did that and i didn't get reasonable values
because i move the sensor 90 degrees and back where he was and i don't get the same values which i get i n the start
Remember that the gyro has a maximum turn rate that it can report. Turning faster than that (which is easy to do when holding the gyro in your hand) will cause signal overflows which translate into lower rotations report than actually occurred.

Try doing your test and turning the gyro VVVVEEEEERRRRRYYYYY SSSSSSLLLLLLLOOOOOOWWWWWWLLLLLLYYYYY and see what happens.

$0.02 from Lynn (D) - Team Voltage 386 Software