Quote:
|
Originally Posted by Kevin Watson
Can you try the software mentioned here and report back with the results?
-Kevin
|
I've been having the same type of error working with our camera. Everything is wired correctly, TTL port is set up, backup battery is charged, program loaded correctly (using the most updated version from your website, Kevin), etc. Everything is verbatim to what I've been reading thus far, and I'm still getting a hangup on STATE 3.
I've downloaded the diagnostic program, and run it. It doesn't show "Serial Port Diagnostics Running..." until after I restart the RC, and when I type something "To Port ->" I get no feedback.
The camera has a green light from what seems to be labeled DS1, DS2 is off, but DS3 is red.
This all seems to say to me, "your TTL port isn't working!!" but I know beyond a doubt I have hooked it up properly. So sould I assume that's a defective part or is there someone out there with more insight into the issue than I have? (I hope, I hope, I hope...

)