Quote:
|
Originally Posted by Peter H
The partial image is complete, as far as it goes - no missing lines. I have used 2 serial cables, both look OK, both give the same result. No motors or robot controller - I run the camera stand-alone on my desk. Battery is fully charged, and voltage stays about 7.5 volts while running. COM1 / Resources shows IRQ 4; no PIO.
Micrsoft Antispyware used 9% of cpu every few seconds. Killed it, but no change. Other processes use 2-3% every few seconds.
LabView is now adequate for my purpose.
|
Just to be clear, does the red light continue to flash after the download bar disappears and the error message pops up?
Thanks,
-Joe