Thread: Servo Offset -> Angle conversion
View Single Post
  #3   Spotlight this post!  
Unread 29-01-2006, 19:06
bush's Avatar
bush bush is offline
Registered User
AKA: Aaron
FRC #0710 (Pine Crest School)
Team Role: Programmer
  
Join Date: Jan 2006
Rookie Year: 2005
Location: Fort Lauderdale, Florida
Posts: 42
bush has a spectacular aura aboutbush has a spectacular aura about
Send a message via AIM to bush
Re: Servo Offset -> Angle conversion
That of course assumes that your CENTER pwm values are at 124 and 144 (not hard to change). But then my next question would be, why would the degree change be different for 2 identical servos?