Quote:
|
Originally Posted by Dzdconfusd
Am I the only one that that the pinnion gear split when I pushed it onto the FP shaft?
We tried to use one of these on a mechanism and after I pulled the gear off the FP (using a bearing seperator and drive pin punch on an arbor press) I went to install it on the FP motor. I did not do anything to the splines but instead tried to press the gear straight on and heard the dreadful pop of the pinnion.
Pete
|
I turned the splines down to about 0.126 because of the high interference - I was kindof afraid of the brass pinion doing something like that. The splines bring the OD out to about 0.130, while BaneBots says the pinion is for a 0.125 shaft OD.