Quote:
|
Originally Posted by billbo911
Basic specs is correct, mostly power, torque, no load RPM and current draw. What I am looking for on the van door motor is the mounting hole layout and thread size and pitch. I know the output shaft is 11mm in diameter, this leads me to believe the mounting holes are metric as well.
|
I don't think I've seen a manufacturer's dimensioned drawing of this motor anywhere but if you go to
FIRSTCADLibrary, Ed has it modeled on the Motors page. He doesn't have the threads spec'ed, and appears to have used inch units, but at least the hole circle is there. I believe you're correct about the metric mounting holes (M6?), anyway.