Thread: Moving holes in an assembly?
View Single Post
  #10   Spotlight this post!  
Unread 03-02-2006, 07:29
Henry Anthony Henry Anthony is offline
Registered User
FRC #1250 (GATORBOTS)
Team Role: Mentor
  
Join Date: Jan 2003
Location: Dearborn, Michigan
Posts: 46
Henry Anthony is on a distinguished road
Re: Moving holes in an assembly?
"If the holes were applyed on a 2D sketch with in the Part, then in the assembly could we apply the extrusion through the board?

Yes and no.

"How?"

You would not "apply the extrusion through the board." In your assembly you should have the board mated to the Part. Within the assembly, start a new sketch on the board. Use the Project Geometry tool to project the holes from the Part on to the sketch. Extrude the holes through the board. The holes on the board will now be adaptive to the holes in the Part.

Does this not solve your problem or am I missing something here.
__________________
Best regards,

Henry