|
Re: Gear Tooth Sensor
Quote:
|
Originally Posted by nukem
I just did a search for INTCON3bits.INT2IF and it was only found in the if statement seeing if it was trigged and when I set it to 0. Where/how do I put code to make it trigger?
|
As you can see from page 125 of this document, the flag is set in hardware and must be reset (cleared) in software.
Quote:
|
Interrupt flag bits are set when an interrupt condition occurs, regardless of the state of its corresponding enable bit or the global interrupt enable bit. User software should ensure the appropriate interrupt flag bits are clear prior to enabling an interrupt. This feature allows for software polling.
|
Does this answer your question?
__________________
Mike Betts
Alumnus, Team 3518, Panthrobots, 2011
Alumnus, Team 177, Bobcat Robotics, 1995 - 2010
LRI, Connecticut Regional, 2007-2010
LRI, WPI Regional, 2009 - 2010
RI, South Florida Regional, 2012 - 2013
As easy as 355/113...
Last edited by Mike Betts : 05-02-2006 at 02:19.
|