Quote:
|
Originally Posted by railerobotics
After downloading the code to the robot controller and the terminal window pops up, nothing happens in it. Why is this?
|
This may have been said already... but it never hurts to say it again.
My team has wasted 4 weeks on the same problem. The code will not load correctly and execute if the robot radio OI (what runs your joystick) is not connected and functioning. The out-of-the box code should always work as long as you have not altered it in any way and have it wired according to the instructions. (PWM 1 & 2 for Pan/Tilt, TTL chip connected to controller, and power pwm cable) To make sure your OI is working, make sure the light next to RADIO on the controller is green, and not red or orange.
I really hope this helps... this camera gets really frustrating. Keep working hard guys, see ya at competition.
~ Team 900 infinity
