Quote:
|
Originally Posted by ForgottenSalad
We've run into a problem here.... Since we're using last year's distro panel, the SLU-35 lugs have too small of a hole to fit onto the bolt on the distro panel. Which would be the legal way to do this... Drill out the SLU-35's hole so it fits the bolt, or use last year's SLU-45 lugs?
|
We ended up drilling ours. It's a little tricky though. I found that the best technique is to sandwich it between two pieces of metal. Take two pieces of 1/4" plate and drill a hole into each of them that matches the current hole on the lug. Sandwich the lug between the two plates and run the bit back through to make sure they're all lined up. Clamp it down and drill through the entire assembly with the appropriate bit.