Quote:
|
Originally Posted by dhoizner
On the banner sensors, there should be four wires: blue, brown, white, and black.
Brown wire is +5
Blue wire is ground
Black and white wires are the signal wires
When using the black wire as your signal pin, your default value is normally closed (0 when unblocked). If using the white wire as your signal, it is normally open (1 when unblocked).
Hope this helps,
|
I'm pretty sure they are 10-18v, not 5. We have them hooked up to a 20A fuse, and they are working fine off 12v. You *really* need to go find the spec sheet though.