|
Re: Chain Tensioners
we had some 'C' channel from the kitbot that we weren't using, and we basically cut it, made a groove through it like that (look below), made a slit so that the bolt can slide (not necessarry, i guess, could just use a wing nut, and remove when want to loosen chain), put a bearing on it (represented by the B in the diagram), which pushes up against the chain (labelled C) and tightened the bolt....presto! if you want more info, feel free to pm me
|C|
|B|
|=|
|=|
[edit]
realized that making the pic better just made it worse
[/edit]
__________________
Rohan K
2008: Alumni, Helper
2007: Webmaster, Alumni
2006: Team Captain, Driver, Electrical/Electronics Head
2005: Safety Captain
Last edited by Rohan_DHS : 13-02-2006 at 23:05.
Reason: got bored
|